Yeap thanks I just got pass that:
enter programming mode:
installer code8000
#93
*192 1 0 ( this is for address 19 since 16,17,and 18 are already taken by 2 keypads and a remote BAT module)
*99
So that's done. When I go to step 7. Establish communication with the AD2USB from the Terminal and step 8. Assign a Keypad Address to the AD2USB all I get is a bunch ??????? after issuing the
cu command. See bellow.
Am I missing something? How do I troubleshoot this?
exiled:dev root# cd /dev/
exiled:dev root# ls -al *usb*
crw-rw-rw- 1 root wheel 10, 3 Dec 21 17:35 cu.usbserial-A8006VSZ
crw-rw-rw- 1 root wheel 10, 1 Dec 21 17:35 cu.usbserial-A8008ZRJ
crw-rw-rw- 1 root wheel 10, 2 Dec 21 14:02 tty.usbserial-A8006VSZ
crw-rw-rw- 1 root wheel 10, 0 Dec 21 14:02 tty.usbserial-A8008ZRJ
exiled:dev root# sudo cu -l cu.usbserial-A8008ZRJ
Connected.
??????????
berkinet wrote:I believe you will want to use field *191 for keypad address 18. The instructions are given in field 190. But, essentially I think you want to enter programmer mode and then press press
*191 1 0 and then *99