finally i managed to get all Infos from my go-e Wallbox via MQTT to indigo. Everthing works smart an fine.
Except one thing: Actual values of voltage, current and power are nested in an array which looks like this:
- Code: Select all
"nrg": [218, 220,221,1,32,33,32,6,6,6,0,[b]203[/b],93,93,94,11]
IF the car is charging, my indigodevice has always the correct an actual value. But if i stop charging, the value of my indigo devices NEVER becomes Zero. It always stays at the last reported value. (Array while not charging looks like this
- Code: Select all
"nrg": [218, 220,221,1,0,0,0,0,0,0,[b]0[/b],0,0,0]
My device is a MQTT Value Sensor Device (s. Attachment)
Any ideas what might be the problem ?
Thanks from Germany
Dirk
PS: Topics in my MQTT looks like this: go-eCharger/028965/status and status is:
- Code: Select all
{"version":"B","rbc":"251","rbt":"2208867","car":"1","amp":"10","err":"0","ast":"0","alw":"1","stp":"0","cbl":"0","pha":"8","tmp":"30","dws":"0","dwo":"0","adi":"1","uby":"0","eto":"120","wst":"3","nrg":[2,0,0,235,0,0,0,0,0,0,0,0,0,0,0,0],"fwv":"020-c1","sse":"000000","wss":"goe","wke":"","wen":"1","tof":"101","tds":"1","lbr":"255","aho":"2","afi":"8","ama":"32","al1":"11","al2":"12","al3":"15","al4":"24","al5":"31","cid":"255","cch":"65535","cfi":"65280","lse":"0","ust":"0","wak":"","r1x":"2","dto":"0","nmo":"0","eca":"0","ecr":"0","ecd":"0","ec4":"0","ec5":"0","ec6":"0","ec7":"0","ec8":"0","ec9":"0","ec1":"0","rca":"","rcr":"","rcd":"","rc4":"","rc5":"","rc6":"","rc7":"","rc8":"","rc9":"","rc1":"","rna":"","rnm":"","rne":"","rn4":"","rn5":"","rn6":"","rn7":"","rn8":"","rn9":"","rn1":""}