scenario: 3000 sq ft house, Indigo with CM11, 10-15 lamp and/or appliance modules, wall outlets, 2 RF receivers for 1-8 & 9-16 A code, plug-in powerline bridge
About half of the remote units do not respond when Indigo sends commands. Initially I thought it was because I needed to bridge the two legs of the power, but running the dryer and using a plug in bridge have had no effect.
Obviously something is eating the signal somewhere. I do have one large SmartUPS 2200 for servers and a couple of smaller UPS units for network gear which are probably eating some of the signals, but when the server gear was in a different location in the house (and the CM11 also in the same room as the UPS) I didn't have these problems. Something, somewhere, is killing my signals.
What is the easiest way to find out what it is and the least expensive way to solve the problems?