gskarp wrote:I'm not sure if I need to remove it from the stick and then try to add it again, or is it just a bad module?
Go ahead and try that. I had the same issue with my DSB05. Removed it from the stick, added it back and it's working again.
gskarp wrote:I'm not sure if I need to remove it from the stick and then try to add it again, or is it just a bad module?
Gusten wrote:This should probably be in a separate thread, but this was the closes one.
Anyone know how the tamper is working?
I get this filling up my log, it almost one every second
Z-Wave received "027 - Tamper" status update is on
GreenhouseAutomation wrote:I am using the Multisensor ZW100A,. I have a few of them in a greenhouse environment, and they are wildly inaccurate on the temperature and humidity (+-20%). Does anyone know of an accurate, maybe +-5% that works with z-wave?
Feb 10, 2017, 11:04:09 PM
Z-Wave received "Back Deck Luminance" sensor update to 0 lux
Z-Wave received "Back Deck Luminance" sensor update to 0 lux
Z-Wave received "Back Deck Humidity" sensor update to 85%
Z-Wave received "Back Deck Humidity" sensor update to 85%
Z-Wave received "Back Deck Temperature" sensor update to 42.2 °F
Z-Wave received "Back Deck Temperature" sensor update to 42.2 °F
Different Computers wrote:My DSB05 just exhaled its magic smoke while I was trying to troubleshoot it.
Anyone have a recommendation for a sensor that isn't a DSB05 that does most of the same things? I don't really care about humidity, but I need luminance. And since the DSB05 has never been very reliable for me, I'd prefer something else.
aldera wrote:I have 2 Zooz 4 in 1 sensors (ZSE40). I've only had them for 3 months but they've been fine, so far.
However, the temperature readings now seem to be frozen in time - no change, no update on the temperature module.
Users browsing this forum: No registered users and 1 guest