Indigo Domotics

I am running Indigo 7.2 on 10.13.6 using a WR800RF32 to communicate with my ds10a and ms10a . Until recently all was good. Then bam....no more comunication. I have restarted the interface restarted the server and still no actionin the event log even though I use the test buttons on all my x10 units


Any thought to where I turn to next?

If none of your RF X10 devices are being received (even after moving one so that it's basically right beside the W800 to try an eliminate RF interference), then it seems likely that either the W800 has kicked the bucket, or maybe the USB adaptor (or driver) is having issues.

the light on the w8000 is on. it shows on system profile indigo turns it on and off according to the log

captcurrent wrote:

the light on the w8000 is on. it shows on system profile indigo turns it on and off according to the log

Based on that, it seems the issue is less likely to be an issue with your USB-to-serial cable. Unfortunately, the LED being on may only mean that it's still getting power, not necessarily that it's working right. That's all I can think of.

Thanks...