For some reason, Indigo 4.1.0 isn't ignoring X10 motion sensors OFF commands when I've selected "After delay of N minutes from when module last sent."

Any ideas?

-j

jingai wrote:For some reason, Indigo 4.1.0 isn't ignoring X10 motion sensors OFF commands when I've selected "After delay of N minutes from when module last sent."

Any ideas?

-j

When you say it's not ignoring them, what exactly do you mean? Is it changing the motion sensor's on/off state to off when it receives the X10 off command?

Note: Indigo will still "see" the OFF command - it just won't change the state of the motion sensor to off until after the delay you specified. If you have any triggers on receiving X10 OFF on that motion sensor, then it's behaving correctly. In order to trigger off the state change, use the "Device State Changed" trigger rather than X10 Command Received.

jay wrote:Note: Indigo will still "see" the OFF command - it just won't change the state of the motion sensor to off until after the delay you specified. If you have any triggers on receiving X10 OFF on that motion sensor, then it's behaving correctly. In order to trigger off the state change, use the "Device State Changed" trigger rather than X10 Command Received.

Ah, that's what I hadn't realized. My triggers were still based on the X10 commands.

Thanks,
Jonathan