Indigo Domotics

I have an alert trigger that notifies me when our greenhouse temperature reaches a set point. The setpoint is a variable (id# 586566111) which goes up or down based on a control page button.

Since my upgrade to indigo 2022.1 (OS Monterey 12.3.1) the trigger will no longer fire. If I use a static number such as 80 instead of %%v:586566111%% the trigger will fire.

Thoughts?

Butch

Post a screenshot of the trigger definition dialog.

here ya go...

Also.... if I try to use the "execute conditional actions" button the trigger will not fire. The "Execute actions only" does fire.

That trigger has never worked - substitutions don't work in the built-in trigger dialogs.

You could do a "has any change" trigger then write a conditional script that would check both your current condition and do the comparison to the variable value.