This topic is to discuss the EZFlora by Smartenit. The Rainbee8, while mainly billed as a Zigbee-based controller, also supports Insteon. Indigo identifies it as an EZFlora and it functions exactly the same.
Device Details
How to use with Indigo
zoneTime = indigo.variables[191822323]
zoneInt = int(zoneTime.value)
# Run schedule
indigo.sprinkler.run(112954509, schedule=[zoneInt, 0, zoneInt, 0, zoneInt, zoneInt, 0, 0])
Sprinkler scheduled "Sprinklers (Front)" zone durations: 5.00, 0.00, 5.00, 0.00, 5.00, 5.00, 0.00, 0.00
Sprinkler turning "Sprinklers (Front)" zone 1 on for 5.00 minutes
Sent INSTEON "Sprinklers (Front) - Ground Cover" on (ack: all valves off)
int led = 13; // Set a variable so we refer to pin 13 as 'led' for better readability...
void setup() {
pinMode(led, OUTPUT); // Most Arduino pins can be digital inputs or digital outputs. this sets pin 13 as an output
}
void loop() { // Loop through everything in this code block
digitalWrite(led, HIGH); //Turn on the output
delay(1000); //wait 1 sec
digitalWrite(led, LOW); //Turn off the output
delay(1000); //Wait 1 sec
}
Users browsing this forum: No registered users and 1 guest