Here you go as I posted. I contact them with a bug. I was very specific as to what the bug was.
Just got my useless answer back from them. They completely did not read what I wrote, and just gave me a half-assed response. Might even be canned.
This is what I wrote them:
Hi,
I have an activity that I have used prior to v5.
It uses my Denon avr main zone as the volume device, and I manually created buttons and a feedback to control the volume of zone 2 of the same AVR. It has always worked nicely.
However, in v5, the volume up/down controls for zone 2 are changing the volume for the main zone.
I double checked that they are set correctly. I recreated them, but it still happens.
From the z2 device control it works correctly. This problem only happens from within an activity.
This is the response I got which does not remotely address the issue, and actually shows that they didn't really read what I wrote.
Hello,
Please try disabling "Force Legacy Remote Design" for the activity if you have the enabled. Then go to Remote Design > Reset Design > Change Remote Design > set to None. Save to exit. Then relaunch that activity and test volume control.
Thank You,
Simple Control Support
With legacy turned off, the custom buttons that I built don't even show up. They know this, they even say this on their website. So legacy must be on. I never said volume doesn't work. I said the the controls for zone 2 were changing the volume of the main zone.
And this came from Jon Lopez as I mentioned in a previous post.