Here:
https://www.indigodomo.com/pluginstore/283/
Changelog from last Release:
Plugin Store version 1.0.1
Update readme information
0.1.22
Refactor speak command
Thread Say for each device (with checks) and timeout if any part of say/conversion fails.
Remove runconcurrent as not used.
Few debugging changes/reduce logging
More logging info depending on what fails at appleTV Library end
Set error state until device is setup/paired. So obvious what is going on.
Support new HomePod in lieu of library recognising
Check for same name on device creation
Report if Unquarantine command xattr doesn't seem to have been run
0.1.20
Add check for correct version of pyatv being installed.
(thanks autolog for the requirements.py)
0.1.19
Change disconnect handling, avoiding potentially leaving loop running
0.1.17
Add exception catching to creation of devices - skipping device if issue
0.1.15
Fill PowerState states. Reflects the onOff state of the device - but PowerState will be Unknown, Idle, or On.
0.1.14
Fix for App name being combined name and identifier, add check for None first.
Add Playing states Stopped, Seeking, in addition to Playing, Idle, Paused
0.1.12
Bug fix for change in Ip address
0.1.11
Save new Ip address in Indigo device details. Enables reconnection to non-static IP addresses. When changes will fail and try to reconnect, should update plugin device with new IP address once connected. Ideally would suggest Static Ip address would avoid this period of disconnection.
Do above when scanning for devices - update existing devices IP's if changed
Change logging multicast mentioned - could have been either.