New to Pico Triggers, but kicking myself for not exploring sooner, fantastic use case!
Using the latest Lutron Plugin. I have setup several buttons and triggers. They all work fine with my Caseta Pro bridge.
I noticed after successfully installing an ADDITIONAL Lutron RA2 Select hub, the pico triggers on most picos would no longer work, but one pico worked every time, even with the new RA2 Select hub enabled.
Why? Thats way above my knowledge, but I can tell you if I enable / disable that RA2 Select bridge in Indigo, all pico triggers work or don't work consistently. EXCEPT a single pico.
Photos -
1 - Plug in version
2- list of buttons. With the RA2 installed AND enabled, device 35 / button 3 works EVERY time, and is further away from hubs than button 13
With the RA2 installed AND enabled, device 13 / button 3 NEVER works , and is closer to the hubs than device 35 / button 3
3. This is the trigger that works EVERY time, no matter the status of the RA2 Select hub being enabled
4. This photo shows the method I finally used vs uninstalling the RA2 select as I tested this issue.
So, 2 basic questions:
1. Any thoughts on why one pico device would consistently work even with the RA2 Select hub enabled while the others wont ?
2. Any suggestions on why the pico triggers seem to get "Confused" when that 2nd hub is enabled ?