we have a 2413U interface which seems to be working fine on one side of our home.
One side of of my home works find but the other side just will not work with X10 or Insteon.
we did a X10 bridge at fuse box.. sometimes the X10 unit may work but not all the time so i am migrating to Insteon devices for controls and that is not "right"
we have gotten a couple of Insteon devices to try and test but they also do not work. The 2413U will see them but not control them with consistency.
i have found some notes on the web to use an extender or range devices ?? 2992-222
do i need one or two of these units ?? and are there any tricks to setting this unit up ??
Will i also need a ?? phases bridge ?? or just the controller and the extender ??
Thanks in advance for any and all advice
Jim Sterling