In particular, it fully enables support for Device Actions > Light/Appliance Controls > Brighten by % | Dim by %
This means you can use another device to control the brightening and dimming of the LIFX device.
I have tested using a Z-Wave Remotec Scene Master ZRC-90 - see http://www.vesternet.com/z-wave-remotec-scene-master
You will need two triggers. The first to do the brightening/dimming while the button is held down and the second to request a LIFX status when the button is released
As an example, to brighten you need to set-up an Indigo Trigger as follows:
- Trigger
- Type: Z-Wave Command Received
- Event: Incoming Command Received from Device
- Edit Event Settings...: From: ZRC-90 Device, Received: Button 1 Held Down
- Condition: As required - not used?
- Actions:
- Type: Brighten by % (Light/Appliance Controls)
- Device: LIFX device
- Amount: 2% (or value as required)
- Trigger
- Type: Z-Wave Command Received
- Event: Incoming Command Received from Device
- Edit Event Settings...: From: ZRC-90 Device, Received: Button 1 Released
- Condition: As required - not used?
- Actions:
- Type: Request Full Status Update (Universal Controls)
- Device:LIFX device
I guess the same could be done with an Insteon dimmer switch but I don't have any Insteon devices?
Hope this might prove useful