Set the LEDs on a Leviton VRCS4 Scene Controller

I recently added a Leviton VRCS4 Scene Controller to my HA network.

Using Indigo Triggers, I've been able to program each button to execute a series of actions for each of the scene buttons.

My challenge is that each button on the VRCS4 has a green LED that stays lit until another button is pushed or until I push the button again to turn off the LED/scene.

Does anyone know the raw command string or strings I can send to the controller to shut off the LEDs. Ideally, I'd like to have the light pop on once the button is pushed and the scene activated then 60 seconds later turn it back off.

I've searched Leviton's site for a listing of command codes and parameters with no luck. It seems each LED can be set to Green, Red or Orange, blinking, etc. so unlocking the ability to send raw commands could actually be used to turn the scene controller into a great trouble monitor as well.

Anybody have any thoughts??

Thanks in advance.

Rob

Subscribed! Something I would really like to implement too. Unfortunately, I've had no luck uncovering the raw commands either.