Hi all,
This is my first post here, so I'm a noob!
I want to connect my 55Q8F to my Mac Mini using the Ex-Link port and a usb to serial adapter.
I bought this: FT232 3.3-5V TTL USB Serial Port Adapter
White: RX (3.3V)
Green: TX (3.3V)
Black: GND (min)
How should I solder these to my 3.5 audio plug. Should the white RX cable go to the tip ore the ring?
The black one is obvious, but i's strugling to figure out the rx / tx part.
I tried both combinations, but I can't get it to communicate with my Mac.
So knowing the wiring is right makes the rest of the troubleshooting easier hopefullt.
BTW I have enabled the Hotel mode, set the RS232 port to UART and disabled Anynet+
No luck so far! Am I missing something?