I purchased one of these off of Amazon and installed it on an older floodlight today:
https://products.z-wavealliance.org/products/2947
Here's the installation instructions for it: https://homeseer.com/wp-content/uploads ... nual2b.pdf
I'm an Insteon guy, so Z-wave is a bit new for me. I do have the Aeotec Gen5 stick hooked to my Mac, and have been able to get this new HomeSeer device into inclusion mode. I have a single device in Indigo for this: Notification Sensor.
My guess is that this device is not supported, because although I can see the state is off, it does not come on when the motion sensor activates the lights (I do see the Z-Wave status bar at the bottom of the Indigo window activate though, so traffic is passing back and forth).
What information can I provide to get this supported?