http://www.szneo.com/en/products/show.php?id=176
I managed to add it to my Z-Wave Network but unfortunately the "open/close" function is not being recognised. The log clear shows something happening. This is what the log says when the device changes from an open to close to open situation.
- Code: Select all
Z-Wave Debug RCVD requestAlarmSensorStatus: 01 0F 00 04 00 13 09 71 05 00 00 00 FF 06 17 00 74
Z-Wave Debug . . requestAlarmSensorStatus: node 019, endpoint None, cmdClass 71, type 0, value 0, classSubKey 710000
Z-Wave Debug . . requestAlarmSensorStatus: typeExt 6, valueExt 23, classSubKeyExt 7100000617
Z-Wave Debug RCVD requestBinarySensorStatus: 01 0A 00 04 00 13 04 30 03 00 0A DF
Z-Wave Debug . . requestBinarySensorStatus: node 019, endpoint None, type 10, value 0
Z-Wave Debug RCVD requestAlarmSensorStatus: 01 0F 00 04 00 13 09 71 05 00 00 00 FF 06 16 00 75
Z-Wave Debug . . requestAlarmSensorStatus: node 019, endpoint None, cmdClass 71, type 0, value 0, classSubKey 710000
Z-Wave Debug . . requestAlarmSensorStatus: typeExt 6, valueExt 22, classSubKeyExt 7100000616
Z-Wave Debug RCVD requestBinarySensorStatus: 01 0A 00 04 00 13 04 30 03 FF 0A 20
Z-Wave Debug . . requestBinarySensorStatus: node 019, endpoint None, type 10, value 255
How can I arrange to get this properly supported in Indigo?