click to enlarge

INSTEON enabled Input/Output Controller with SmartLabs PowerLine Module (PLM) is now available!

EZIO8SA allows inputs and outputs from external devices to be connected to Insteon and X10 networks at the point of need. External events such as contact closures can be detected or monitored through up to 7 inputs. One of the inputs can be programmed as a 1-Wire bus such that it can be used to connect sensors compatible with this protocol. The inputs can trigger an INSTEON group command to cause any activity by a responder in the network. Eight outputs driven by form-C relays can be used to control AC and DC loads of up to 3 Amps. Control and monitor anything in your Indigo based Insteon/X10 home automation network with EZIO8SA!

(NOTE: Indigo 2.0.5 or greater, in tandem with the INSTEON PowerLinc V2 Controller 2414U is required to use the EZIO8SA.)

AND . . . ANOTHER NOTE: Indigo must be running on your Mac for the EZIO8SA to be controlled. You cannot upload your related triggers and schedules that involve the EZIO8SA into the PowerLinc Controller 2414U and then turn off your Mac. See these helpful Indigo hardware compatibility tables.

Specifications (EZIO8SA):

• Dimensions (inches) : 1" x 3.9" x 3.1" (excluding external connectors)
• Weight: 5 oz
• Operating Conditions: Indoors, 32-122 degrees F; 0-85% relative humidity
• Input: 7 total. Four digital opto-isolated inputs requiring a voltage between 3 and 30 volts to activate on.; Two other inputs may be analog or digital, 0-5VDC max.; Final input is digital input or 1-Wire bus, 0-5VDC max. on its own dedicated connector.
• Output: 8 - Driven by relays; Rated 3A, 120VAC or 24 VDC
• Warranty: 1 year

• Supply Voltage: 120 Volts AC +/- 10%, 60 Hertz, single phase
• Power Plug: 3-pin grounded
• Pass-through Outlet: 3-pin grounded
• Controlled Outlet: 3-pin grounded
• Maximum Amps: 15 (for resistence loads)
• Warranty: 1 year

• EZIOSA Input/Output Controller
• PowerLine Modem (PLM)
• Cat 5 Cables
• PLM Data Cable
• Quick Start Guide